| Author |
Thread |
|
Mortis
Advanced Member
United Kingdom
7,493 posts
Joined: May, 2004
341 hardcore releases
|
 Posted - 2007/06/21 : 22:31:21
Does anyone know how to link cutoff in z3ta to an automation clip in FL7?
__________________________________
"Maybe in a day and age in which even our rappers can't get to the end of a verse without having an existential crisis, we should find a place for happy hardcore"
Alert moderator 
|
Orbit1
Senior Member
Australia
400 posts
Joined: Jul, 2006
|
Posted - 2007/06/21 : 22:39:22
the midi CC should be 74.
__________________________________
http://myspace.com/orbit1dj
Alert moderator
|
Mortis
Advanced Member
United Kingdom
7,493 posts
Joined: May, 2004
341 hardcore releases
|
Posted - 2007/06/21 : 23:31:37
Cheers Sam, can't get it to do anything though. I'm using an xbox360 pad as the XY controller, not sure if it works though although I have read that you can use them 
__________________________________
"Maybe in a day and age in which even our rappers can't get to the end of a verse without having an existential crisis, we should find a place for happy hardcore"
Alert moderator
|
Hard2Get
Advanced Member
United Kingdom
12,837 posts
Joined: Jun, 2001
|
Posted - 2007/06/22 : 10:34:04
quote:
Originally posted by Mortis:
Does anyone know how to link cutoff in z3ta to an automation clip in FL7?
Is that how you normally link stuff? If not, go to the top left and corner of the plug and click the drop down menu, then select 'Browse Parameters' and search for cutoff/frequency (if it's hard to find, adjust the control for that on Z3ta so it goes straight to that parameter), then right click the parameter and select 'Link to controller', make sure auto detect is selected (it should be by default), then move the controller you wish to assign the parameter to and it will link it to that controller (assuming it is set up right) :)
Note: to assign several controllers to the same parameter you need to switch off 'Remove Conflicts'.
Alert moderator
|
Printer friendly
